Skip to content


Ark Epoxy 2:1 Pump Set

Original price $15.33 - Original price $15.33
Original price
$15.33 - $15.33
Current price $15.33


Push extension tube firmly into the bottom of the BLUE DOT pump, this is the ARK Resin Pump.  Hold the pump against the side  of the resin container so the cap is level with the container cap, mark and cut the extension tube  at an angle about 3/8” from the bottom. Insert pump in container.

Repeat with the with the RED DOT Hardener pump.   


Depress pumps several times until you get a steady stream.  Discard this mixture.  Use only full pump strokes, improper mix, either too much or too little will result in improper cure.  When dispensing more than .75 oz at a time repeat one resin, one hardener instead of trying to keep track of  ???  shots of resin and hardener.  Mix thoroughly scraping sides and bottom of container before using.

ONE stroke on each pump will produce 3/4oz-22ml  mixed epoxy.

At low temperatures, viscosity increases, and could cause pump breakage from  having to press to hard or produce an incorrect ratio.  Keep the Epoxy at room temperature until you are going to use it.


Leave the pumps mounted on the containers for storage, cleaning with solvent could damage the pump seals resulting in incorrect mix.  After long term storage do a sample batch or measure with graduated containers to check ratio before using on a project.

Store epoxy at room temperature, keep upright and off of concrete floors.  Do not freeze.